Power supply: 220V +/- 10% 50Hz~60Hz
Power: <6.5W
Pressure: 1.6MPA
Working Circumstance:Air temperature: 5~40℃
Pipe water fluxion temperature: 5~90℃
Valve Action time:open time ≤ 13s closing time ≤ 7s
Port size:1/2~1”(15~25mm)
The SW-B... series motorized spring return ball valve of Motor Valve is used for the control of the ends of center A/C. Thermostat control the motor of the Valve, and make on/off through speed-down machine and reset spring to carry out the break/on of the hot/cold water in the pipe.
Model | Valve type | Valve size | Medium | Admissible pressure | Closing pressure | Time (sec) |
electric actuator brass valve | ||||||
SW-B152H | 2 way | 1/2'' | cool/hot water 50% glycol | 1.6 MPa | 1400 KPa | Fission valve: Open time: 14-18s Close time: 5~7s Form-fitting valve: Open time: 8-12s Close time: 3~5s |
SW-B202H | 3/4'' | |||||
SW-B252H | 1'' | |||||
SW-B153H | 3 way | 1/2'' | ||||
SW-B203H | 3/4'' | |||||
SW-B253H | 1'' |
Valve Body
P/N | Port size | KV value | Close P(MPa) |
2 way ball valve | |||
DN15 | 15mm | 2.2 (2.5) | 0.22 |
DN20 | 20mm | 3.0 (3.5) | 0.20 |
DN25 | 25mm | 6.9 (8.0) | 0.18 |
3 way ball valve | |||
DN15 | 15mm | 2.6 (3.0) | 0.22 |
DN20 | 20mm | 3.4 (4.0) | 0.20 |
DN25 | 30mm | 6.5 (7.5) | 0.18 |
Instruction of operation and Installation
1.Feed line and return pipe of differential pressure should be controlled within the range allowed pressure difference.
2.The valve should be installed somewhere easy to install and maintain.
3.Horizontal installation, that’s mean the motor should be in the above of valve body to avoid humidity.
4.When install 3 way valve, infall is on the bottom of valve (no signal showed)